Later on I also put some weight (two books) onto the cloth to press it firmly onto the wood. I put the wood pieces into a vise to make sure they are properly aligned and stay that way until the glue fully dries. I just used regular craft glue and submerged them in it. I used a bit of masking tape wrapped around the drill bit to get the right depth. Then I drilled the holes for the magnets.ĭouble check your measurements and markings to make sure the magnets will align on top of each other, since they are quite small. Unfortunately this worked only partially, so I still had to sand down some of the wood (because the glue won’t stick on oily wood). ![]() I tried to prevent the oil from leaking to the inner side by putting on some masking tape. I will glue the blue felt in the foreground onto both of the wood pieces to use it as a hinge.Īfter cutting two big, circular holes into (but not through!) the wood, I continued with oiling up the box (i.e. In this picture you can also see the awesome grain of the tree. I left the bark intact because I think it nicely adds to the look. This is not an issue with oil, since you can always just reapply the oil.įor this purpose, I cut out two more pieces (5cm x 5cm) from the wood. Once that happens the wood will become pale. gets little cracks) and water can penetrate the wood. it’s sealed), an object like a ring is easily banged against some other hard object. I chose oil instead of clearcoat because while theoretically the clear coat protects the wood from any water (i.e. The woods soaks up the oil which pronounces the color and also protects the wood from fingerprints and humidity. That’s why the ring looks a bit dull: it’s covered in very fine dust.Īfter doing the fine sanding and cleaning the ring (with a clean cloth), I put it into wood oil for half an hour and let it dry for a day. This process takes a ton of patience and good will.īut once I arrived at this stage I knew the effort was worth it.Īfter using the abrasive sand paper (80) to get the shape, I switched to finer ones (600 and then 2000). I used an electric hand grinder (used to work on walls etc.) to get rid of the more pronounced corners. Then put the drill into the machine, spin it around and grind it down with sand paper.īy now the ring already has a circular shape. I used one big drill bit and wrapped some masking tape around it until the ring fits really snuggly. ![]() I will use the setup shown above later to get the finishing grind on the ring: It’s still very squared, but at least you can kind of imagine it’s a ring now. These two features come into one’s one after polishing and oiling the wood.Īfter choosing the right area of the wood (looking at the shape and direction of the grain), I cut out a little 3cm x 3cm piece.Īfter I cut out the hole in the middle (I choose 15mm because I can always expand the diameter), I started trimming down the edges along the outside. Perfect for creating a small yet sturdy object.Īdditionally, cherry wood also features an easily visible grain and has the characteristic red-ish color. ![]() This is where the journey started: just a nice and straight sheet of cherry wood that I found in my grandfather’s basement.Ĭherry trees grow slowly, thus their wood is very hard.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |